Campbell-scientific 27106T Gill Propeller Anemometer Manuel d'utilisateur

27106T Gill Propeller AnemometerRevision: 2/11Copyright © 1984-2011Campbell Scientific, Inc.

27106T Gill Propeller Anemometer TABLE 5-1. Wind Speed Multiplier (With Configuration Code 21*) Unit Multiplier Miles per Hour 0.04025 Meters/Se

27106T Gill Propeller Anemometer 'Define Data Tables DataTable (Table1,True,-1) DataInterval (0,10,Min,10) Maximum (1,WS_ms,FP2,False,False) M

27106T Gill Propeller Anemometer 6: Minimum (P74) 1: 1 Reps 2: 0 Value Only 3: 1 Loc [ WS_ms ] 7: Average (P71)^4771 1: 1 Re

27106T Gill Propeller Anemometer c) Loosen set screw on shaft collar/coupling disk and remove from propeller shaft. d) Slide propeller shaft t

27106T Gill Propeller Anemometer Replace the tach-generator as follows: 1. REMOVE OLD GENERATOR ASSEMBLY a) Remove propeller from anemometer.

27106T Gill Propeller Anemometer Drinkow, R., “A Solution to the Paired Gill-Anemometer Response Function”, Journal of Applied Meteorology, Vol 11, 19

27106T Gill Propeller Anemometer 12

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

Warranty and Assistance The 27106T GILL PROPELLER ANEMOMETER is warranted by Campbell Scientific, Inc. to be free from defects in materials and workma

27106T Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab fo

27106T Gill Propeller Anemometer 1. General Description The 27106T Gill Propeller Anemometer sensor is used to measure vertical wind speed. Wind spee

27106T Gill Propeller Anemometer Dimensions Overall Length: 17 inch (43 cm) Propeller Diameter: 8 inch (20 cm) Housing Diameter: 1 inch (2.5 cm

27106T Gill Propeller Anemometer Once everything has been retrieved from the shipping carton, assemble the 27106T by doing the following: 1. Remove

27106T Gill Propeller Anemometer Mounting Pipe FIGURE 3-1. 27106T Mounted to a Crossarm via the CM220 FIGURE 3-2. 27106T Mounted to a Crossarm via

27106T Gill Propeller Anemometer 4. Wiring Connections to Campbell Scientific dataloggers are given in Table 4-1. When Short Cut for Windows softwar