Campbell-scientific EC150 CO2 and H2O Open-Path Gas Analyzer and EC100 Manuel d'utilisateur Page 47

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 86
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 46
EC150 CO
2
/H
2
O Open-Path Gas Analyzer
TABLE 8-3. Diagnostic Flags and Suggested Actions
Flag
Number Flag Name Comments
18 CO
2
Signal
Strength
Set if the ratio of the CO
2
measurement
and the CO
2
reference signals are
outside prescribed limits. It can be
turned on when the measurement path is
obstructed by insects, dust, precipitation,
condensation etc. If it persists, consult
with a Campbell Scientific application
engineer.
19 H
2
O Signal
Strength
Set if the ratio of the H
2
O measurement
and the H
2
O reference signals is outside
prescribed limits. It can be turned on
when the measurement path is
obstructed by insects, dust, precipitation,
condensation etc. If it persists, consult
with a Campbell Scientific application
engineer.
20 Calibration Error Set if there is a problem reading or
writing into the analyzer’s head
memory. Power off the EC100 and
reconnect the head. If the flag persists,
consult with a Campbell Scientific
application engineer. For more
information on the head memory refer to
Section 4.3, Gas Head Memory.
21 Heater Ctrl Off
22 Not Used
37
Vue de la page 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 85 86

Commentaires sur ces manuels

Pas de commentaire