Campbell-scientific ENC10/12, ENC12/14, ENC14/16, ENC16/18 Enclosures Manuel d'utilisateur télécharger pdf (Page 41)

Appendix C. 28960 Stack Mounting Kit

C.1 Introduction

The 28960 Stack Mounting Kit is used to raise a component 3 in above the

surface of the back plate. This is beneficial when an enclosure nears its holding

capacity of components. Using the Stack Mounting Kit allows one component

to be stacked above another, saving space in the enclosure. For example,

FIGURE C-1 and FIGURE C-2 show a CR1000 mounted above an

AM16/32B. Any component mounted below the Top Grid must be fully wired

prior to installing the Top Grid. Note that in this example, the four grommets

used to mount the CR1000 to the Top Grid pass through the Top Grid into the

Legs using the same hole pattern as the CR1000.

CR1000

AM16/32B

Leg

Top Grid

Leg

Enclosure

Back

Plate

Screw

Grommet

FIGURE C-1. Exploded view of a CR1000 and AM16/32B mounted on

a 28960 Stack Mounting Kit

C-1

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Pas de commentaire

Campbell-scientific ENC10/12, ENC12/14, ENC14/16, ENC16/18 Enclosures Manuel d'utilisateur Page 41