Campbell-scientific CS125 Present Weather Sensor Manuel d'utilisateur télécharger pdf (Page 18)

CS125 Present Weather Sensor

Drill four 12 mm diameter holes using the mount base as a template or following

the drawing below to a depth of 77 mm.

Clean the holes of all debris.

Place washers and nuts on the ends of the wedge anchors supplied (to protect the

threads during installation).

Hammer the wedge anchors into the holes until the start of the threads are below

the surface.

Tighten the nuts until about 25 mm of thread protrudes above the surface.

Remove the washers and nuts from the protruding length screw. Then lower the

mount into place.

Finally secure the mount with the washers and nuts.

If the surface is not level and flat it may be necessary to add washers under the

base on one or more of the foundation screws.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 65 66

Pas de commentaire

Campbell-scientific CS125 Present Weather Sensor Manuel d'utilisateur Page 18