Campbell-scientific CPEC200 Closed-Path Eddy-Covariance System Manuel d'utilisateur télécharger pdf (Page 95)

Appendix F. Installing the AC/DC

Power Adapter Kit

The AC/DC Power Adapter Kit is configurable within the CPEC200 system

enclosure to allow the CPEC200 to be powered from AC mains power. A

peripheral mounting kit (pn 16987) is necessary to install the AC/DC adapter

into the CPEC200 system enclosure. The mounting kit includes a bracket, a

Velcro

strap, and the necessary nuts and screws.

The following steps describe the mounting procedure.

1. Install the peripheral mounting kit inside the CPEC200 system

enclosure by threading the Velcro

strap through the bracket.

2. Place the bracket at the backplate of the enclosure below the

datalogger and attach it with the screws included in the mounting kit

(see FIGURE F-1).

FIGURE F-1. Peripheral mounting kit installed in CPEC200 enclosure

3. Place the power supply on the mounting bracket and secure the power

supply’s cable to the back of the mounting bracket with a wire tie as

shown in FIGURE F-2.

F-1

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 111 112

Pas de commentaire

Campbell-scientific CPEC200 Closed-Path Eddy-Covariance System Manuel d'utilisateur Page 95