Campbell-scientific CR10X Measurement and Control System Manuel d'utilisateur télécharger pdf (Page 267)

APPENDIX G. DATALOGGER INITIATED COMMUNICATIONS

G-3

• On the DataCollection screen,

“Data File Name” must be verified.

(Weather.DAT for this example,

Figure G.3-4). This does not have

to be the same name as the

datalogger.

Optional:

• On the Datalogger’s Schedule

screen, the “After Call Do” must be

verified. This is the place to put the

name of a Task to run after the call.

The Task is an optional fourth

Device that would run a batch file

(.BAT) or program after the data

has been collected and before the

computer returns to the wait mode

to wait for incoming calls. (This

example does not run a Task after

collecting the data so this field is

blank, Figure G.3-5).

Once the network’s connection settings are

saved, manually attempt to call the station and

collect data to make sure it is setup correctly.

Once the settings are saved, PC208W will

automatically start waiting and watching for

incoming calls. In the Status window, you can

view information concerning last communication

with the site. As calls are answered and data is

collected, the Status window will update the

information displayed on the screen.

To deactivate PC208W from waiting for a call,

1) modify the COM Port’s Hardware

configuration to not Allow Callback or 2) exit

PC208W.

CAUTION: If a COM port is setup to Allow

Callback, the Storage Module software (Stg

Module) may not function if there is a COM

port or IRQ conflict.

FIGURE G.3-1. Example Network Settings

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 361 362

Pas de commentaire

Campbell-scientific CR10X Measurement and Control System Manuel d'utilisateur Page 267