Campbell-scientific CS215 Temperature and Relative Humidity Probe Manuel d'utilisateur télécharger pdf (Page 26)

CS215 Temperature and Relative Humidity Probe

Sensing part of

element NOT on

the center line

Center line of the

sensor body

FIGURE 9-2. Incorrect fit of sensor element (side view)

10. Attributions and References

AASC, 1985: The State Climatologist (1985) Publication of the American

Association of State Climatologists: Heights and Exposure Standards for

Sensors on Automated Weather Stations, v. 9, No. 4 October, 1985.

(www.stateclimate.org/publications/state-climatologist/NOAA-NCY-

SCBOOKS-SC77097/00000029.pdf)

EPA, 2008: Quality Assurance Handbook for Air Pollution Measurement

Systems, Vol. IV, Meteorological Measurements, Ver. 2.0, EPA-454/B-08-

002 (revised 2008). Office of Air Quality Planning and Standards,

Research Triangle Park, NC 27711.

Goff, J. A. and S. Gratch, 1946: Low-pressure properties of water from -160°

to 212°F, Trans. Amer. Soc. Heat. Vent. Eng., 51, 125-164.

Lowe, P. R., 1977: An approximating polynomial for the computation of

saturation vapor pressure, J. Appl. Meteor., 16, 100-103.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Pas de commentaire

Campbell-scientific CS215 Temperature and Relative Humidity Probe Manuel d'utilisateur Page 26