Campbell-scientific EnviroSCAN Sentek Water Content Profile Probe Manuel d'utilisateur télécharger pdf (Page 20)

Appendix A. Probe Assembly

“Loosely” attach the handle to the rod with two of the large screws that came

with the assembly as shown in Figure A-3.

FIGURE A-4. Location of Small Main Board Screws

FIGURE A-5. Securing Main Board Electrical Connection

Install the main board assembly as shown in Figure A-4 between the two sides of

the mounting rail. The header is plugged into the first connector in the rail as

shown in Figure A-5. Secure the main board to the probe with two of the small

screws that came with the assembly. Tighten the two large screws.

FIGURE A-6. Possible Sensor Positions

A-2

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Pas de commentaire

Campbell-scientific EnviroSCAN Sentek Water Content Profile Probe Manuel d'utilisateur Page 20