Campbell-scientific OBS3 Turbidity Sensor Manuel d'utilisateur

INSTRUCTION MANUALInterfacing theOBS-3 Turbidity Monitor withCampbell Scientific Dataloggers10/05Copyright (c) 1998-2005Campbell Scientific, Inc.

Interfacing the OBS-3 Turbidity Monitor with Campbell Scientific Dataloggers 6 This is a blank page.

This is a blank page.

Campbell Scientific CompaniesCampbell Scientific, Inc. (CSI)815 West 1800 NorthLogan, Utah 84321UNITED [email protected]

Disclaimer This manual concerns interfacing another manufacturer’s product with our dataloggers. We will attempt to provide accurate and up-to-date i

i OBS-3 Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab f

This is a blank page.

1 Interfacing the OBS-3 Turbidity Monitor with Campbell Scientific Dataloggers The OBS-3 Turbidity Monitor is a submersible probe manufactured and sol

Interfacing the OBS-3 Turbidity Monitor with Campbell Scientific Dataloggers 2 Red12V1H1LGGWhiteGreenBlackJumperCR510, CR500 & 21X FIGURE 2. Wiri

Interfacing the OBS-3 Turbidity Monitor with Campbell Scientific Dataloggers 3 2. Programming Use Short Cut, Edlog, or the keyboard/display to progra

Interfacing the OBS-3 Turbidity Monitor with Campbell Scientific Dataloggers 4 ;Read millivolt signal 3: Volts (DIFF) (P2) 1: 1 Reps 2: 25 2

Interfacing the OBS-3 Turbidity Monitor with Campbell Scientific Dataloggers 5 2.4 CRBasic Program Example 'CR1000 'Declare Variables and