Campbell-scientific Sentek EasyAG Installation Guide v 3.0 Manuel d'utilisateur télécharger pdf (Page 34)

Installing EasyAG 80 probes

3. Ensure that the sealing gasket on the top cap is clean, in good condition and positioned correctly,

and replace the lid of the top cap. Tighten the screws evenly completely to ensure an effective seal.

4. Tighten the FairRite bead and into position and tighten the cable gland. The probe is now installed

and upon connection to the data logger is ready for use.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39

Pas de commentaire

Campbell-scientific Sentek EasyAG Installation Guide v 3.0 Manuel d'utilisateur Page 34