Campbell-scientific Sentek EnviroSCAN Access Tube Installation Guide Manuel d'utilisateur télécharger pdf (Page 41)

Installing EnviroSCAN, EnviroSMART & Diviner 2000 access tubes

Installation procedure

Step 1 – Glue in bottom stopper

The slurry bottom stopper should be glued into the access tube prior to installation. Allow sufficient time for

the PVC glue to dry.

To prepare the access tube

1. Use PVC cleaning fluid to clean the bottom rim of the slurry bottom stopper and the inside of

the access tube.

2. Use PVC glue and apply evenly to both surfaces.

3. Insert the slurry bottom stopper into the access tube and hold in place until the glue sets.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 56 57

Pas de commentaire

Campbell-scientific Sentek EnviroSCAN Access Tube Installation Guide Manuel d'utilisateur Page 41