Campbell-scientific 092 Barometric Pressure Sensor Manuel d'utilisateur télécharger pdf (Page 17)

Appendix A. Analog Output

Configurations

The 092 ships from Campbell Scientific pre-wired and pre-configured for

analog output with the following settings:

• Analog Output Voltage: 0 to 5 Vdc

• Range: 600 to 1100 mbar

Output voltage and measurement ranges are set by switches. Dip switch

settings are listed in TABLE A-1 and TABLE A-2. Highlighted settings are

those set at the factory by Campbell Scientific. Complete information

concerning measurement, output, and communications settings is available in

the Met One 092, 594, 6633A Barometric Pressure Sensor Manual, which is

available at www.campbellsci.com.

TABLE A-1. Dip Switches SW1:

Analog Output Voltage Settings

Range SW1-1 SW1-2

0-1 Vdc On On

0-2 Vdc On Off

0-2.5 Vdc Off On

0-5 Vdc* Off* Off*

*Factory configuration at Campbell Scientific.

A-1

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Campbell-scientific 092 Barometric Pressure Sensor Manuel d'utilisateur Page 17