Campbell-scientific 108-LC Temperature Probe for MetData1 Manuel d'utilisateur télécharger pdf (Page 8)

Model 108-LC Temperature Probe for MetData1

3. Installation and Wiring

The 108 must be housed inside a radiation shield when used in the field for air

temperature measurement. The 41303 Radiation Shield (see Figure 3-1)

mounts to a CM6 or CM10 tripod. The UT018 mounting arm and UT6P

Radiation Shield are used to mount the 108 to a UT30 tower.

The standard lead length of 6 feet and 9 feet allow the 108 to be mounted at a 2

meter height on the CM6/CM10 tripod or the UT30 tower respectively.

FIGURE 3-1. 108 and 41303 Radiation Shield

on a CM6/CM10 Tripod Mast

4. Connection

The 108 cable is attached to the MetData1 connector #4 or #7. Connector #4

uses single-ended input 4L (channel 8) and connector #7 uses single-ended

input 5H (channel 9). The probe is measured by a single-ended analog input

channel.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Campbell-scientific 108-LC Temperature Probe for MetData1 Manuel d'utilisateur Page 8