Campbell-scientific CR9000X Measurement and Control System Manuel d'utilisateur télécharger pdf (Page 23)

100

101

Quick Start

QS2.4 Program Generator Output Table Window

Click on Enable to set-up a Data Table. Click

in the Table Name box and enter a name for

your Data Table (up to 8 characters).

Each table interval is

independently set or

Synchronized to the

program scan interval.

Select mSecs and

enter 50 in the

numeric box (output

to the Table at a rate

of 20 Hz).

Select the

media where

the DataTable

is to be stored

Check the Auto Size box. This will cause the CR9000X to allocate

the largest possible table size for the media selected at compile time.

Specified table sizes will be allocated first, then memory for the

auto-size tables will be allocated to fill at nearly the same time.

Output tables are the data bases created by the CR9000X. They may either

reside within the CR9000X memory or on PCMCIA cards, and may be

accessed with the real-time capabilities of the RTDAQ software. The

Program Generator allows you to create and configure up to 6 tables. Click

on Done after the Data Table is set up.

QS-15

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 441 442

Commentaires sur ces manuels

Pas de commentaire

Campbell-scientific CR9000X Measurement and Control System Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Campbell-scientific CR9000X Measurement and Control System