Campbell-scientific CS511 Dissolved Oxygen Probe Manuel d'utilisateur télécharger pdf (Page 31)

Appendix B. Sensorex’s Model

DO6200/T

Prior to June 2008, Campbell Scientific’s CS511 was Sensorex’s model

DO6200/T (see FIGURE B-1) instead of Sensorex’s model DO6400/T.

Programming, wiring, and some specifications are the same for these two

sensors. However, they look different and use different accessories.

FIGURE B-1. Sensorex’s model DO6200/T

B.1 DO6200/T Specifications

Principle of Measurement:

Membrane covered, galvanic oxygen probe

Output Signal:

1.65 mV ± 0.45 mV per mg/l

Accuracy:

Better than ± 2 % of reading ± 1 digit when

calibration temperature equals measuring

temperature ± 5°C

Output Impedance:

10 kΩ nominal

Response Time:

After equilibration, 2 min. for 90% of final

value

Materials of Construction:

Probe body:

O-rings:

Membrane:

Delrin

Membrane O-ring = Buna N

Body Seal O-ring = Viton

0.05 mm Teflon

B-1

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Pas de commentaire

Campbell-scientific CS511 Dissolved Oxygen Probe Manuel d'utilisateur Page 31