Campbell-scientific CSAT3 3-D Sonic Anemometer Manuel d'utilisateur télécharger pdf (Page 14)

CSAT3 Three Dimensional Sonic Anemometer

2.4 Power Requirements

VOLTAGE SUPPLY: 10 to 16 Vdc

POWER:

2.4 W @ 60 Hz measurement frequency

1.2 W @ 20 Hz measurement frequency

3. Initial Setup

3.1 Factory Settings

• Analog Outputs – Off

• Execution Parameter – 10 Hz (see Section 10.3 and B.1)

• Trigger Source – Internal Clock (see Section 8, 9, and B.1)

• SDM Address – 3 (see Section 3.2, 6.1, and 10.3)

• RS-232 baud rate – 9600 bps (RS=0) (see Section 12 and Appendix B)

• Software RTS – Off (RI=0) (see Section 12 and Appendix B)

• Unprompted Output – Off (&=0) (see Appendix B)

The above settings can be changed with a PC, running the CSAT3 PC support

software (CSAT32.EXE), and the RS-232 cable. A copy of the CSAT3 PC support

software is available from the Campbell Scientific web site in the Support|Downloads

section.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 73 74

Pas de commentaire

Campbell-scientific CSAT3 3-D Sonic Anemometer Manuel d'utilisateur Page 14