Campbell-scientific HydroSense II Support Software User Guide Manuel d'utilisateur télécharger pdf (Page 30)

Section 4. Viewing Data

4.2 Showing / Hiding Zones

Zones menus in the Data and Chart tabs facilitate showing or hiding

measurements by zone.

By default, all zones are shown and listed in alphabetical order; clear the Select

All checkbox to enable individual zone checkboxes.

Clearing individual zone checkboxes will remove measurements from those

zones. If the Select All checkbox is cleared and no individual zones are

selected, no data are displayed.

The [Unspecified Zone] is a special zone that contains all the points that are not

located in any of the other zones. The [No GPS Lock] zone is a special zone

that contains all the points that were collected without positional information.

4-4

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 81 82

Pas de commentaire

Campbell-scientific HydroSense II Support Software User Guide Manuel d'utilisateur Page 30