Campbell-scientific HydroSense II Support Software User Guide Manuel d'utilisateur télécharger pdf (Page 67)

Section 7. Error Codes

7.3 (0x01) UserAbort

User aborted the operation.

This error is shown when a connection or synchronization attempt is cancelled

by clicking the Cancel button.

This error does not normally indicate a problem with communications;

however, if it is displayed without the Cancel button being pressed, and it

prevents normal operation of the software, please contact Campbell Scientific.

7.4 (0x10) BTUnkownError

An unknown error has occurred during Bluetooth communications.

This error is shown when communication with the HydroSense II has failed

and the Bluetooth driver on the local computer did not specify the cause of the

failure.

If this error has occurred, attempt to reproduce the error a second time by

following the same steps that resulted in the first error.

If the error is confirmed, please report the error to Campbell Scientific with the

steps required to reproduce the error.

7-3

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 81 82

Pas de commentaire

Campbell-scientific HydroSense II Support Software User Guide Manuel d'utilisateur Page 67