Campbell-scientific CS470/CS471 Compact Bubbler System Manuel d'utilisateur télécharger pdf (Page 19)

CS470/CS471 Compact Bubbler System

7.4 Connect Tubing to the CS470/CS471

1. Cut the bubble tube at a 90° angle with a sharp knife (not scissors).

2. Insert the tubing as far as possible into the tube fitting.

3. Rotate the nut until finger tight.

4. Tighten the nut with a wrench about one and one-quarter turns.

7.5 Bubble Chamber Installation

1. Install conduit (metal or plastic) from the CS470/CS471 to where the

bubble chamber will be located. There should be a continuous drop from

the CS470/CS471 to the bubble chamber (see FIGURE 7-2).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 45 46

Pas de commentaire

Campbell-scientific CS470/CS471 Compact Bubbler System Manuel d'utilisateur Page 19