Campbell-scientific CS470/CS471 Compact Bubbler System Manuel d'utilisateur télécharger pdf (Page 20)

CS470/CS471 Compact Bubbler System

FIGURE 7-2. Bubble Chamber Installation

2. Fasten the conduit in place

3. Attach an elbow or tee joint at the bubble chamber location. The elbow or

tee joint should terminate with a 2-inch NPT female threaded connection.

4. Route the tubing through the conduit.

5. Cut the tubing at a 90° angle with a sharp knife (not scissors).

6. Detach the NPT adapter from the bubble chamber by unscrewing the three

hexagonal screws of the bubble chamber’s flange (see FIGURE 7-3).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

Pas de commentaire

Campbell-scientific CS470/CS471 Compact Bubbler System Manuel d'utilisateur Page 20